Volume 12, Tab 17

Eaton Corporation’s equipment identified below was tested for seismic withstand capability and tested in accordance with the combined requirements specified in the International Building Code, the California Building Code, and the Uniform Building Code.

Equipment representing the products listed below were subjected to seismic testing in accordance with the 2012 International Building Code (IBC) and the 2013 California Building Code (CBC)

Eaton Corporation’s equipment identified below was tested for seismic withstand capability and tested in accordance with the combined requirements specified in the International Building Code, the California Building Code, and the Uniform Building Code.

The trip unit test kit is used to test and verify the pickup levels and time delay settings of a breaker’s trip unit. the original test kits were developed to test the amptector trip units of the DS Breaker. With the introduction of microprocessor based Trip units (Digitrip, Optim, etc), modifications to the original test kits (-G01 and –G02) were required to accommodate lower power requirements of the microprocessor. These modifications, in combination with various test kit adapters, allow maintenance personnel to utilize the test kit they already own when testing the newer generations of trip units.

DSII low-voltage switchgear technical data

DSII low voltage AC power circuit breaker equipped with 1600-5000 Amp Digitrip OPTIM trip units response: long delay I2t, short delay I2t

DSII low voltage AC power circuit breaker equipped with 1600-5000 Amp Digitrip OPTIM trip units response: long delay i2t, short flat

DSII low voltage AC Power circuit breaker equipped with 200-1200 Amp Digitrip OPTIM trip units response: instantaneous

DSII low voltage AC Power circuit breaker equipped with 200-1200 Amp Digitrip OPTIM trip units response: long delay I2t, short delay I2t

DSII low voltage AC power circuit breaker equipped with 200-1200 Amp Digitrip OPTIM trip units response: long delay I4t, short flat